6
PREPARING YOUR SPECIAL BREW COFFEE MAKER
Cleaning your coffee maker before using the first time
• Wash the Glass Carafe, Carafe Lid and the Removable Cone Style Filter Basket in a mixture of mild
detergent and water. Rinse each with clean water thoroughly. (Please refer to the parts diagram).
• Replace all the parts and close the lid. Then, run a brew cycle with water only, without adding
coffee and coffee filter.
• When brewing is complete, turn your coffee maker off, discard the water in the Glass Carafe and
rinse the Glass Carafe, Carafe Lid and the Removable Cone Style Filter Basket.
SETTING THE CLOCK AND DELAY BREW TIME
• Plug the power cord into a standard electrical outlet. The clock will flash on indicating that the
time has not yet been set.
• Press the HR and MIN Buttons, until you reach the current time.
NOTE:
Pressing any button before setting the clock will cause the clock to start keeping time from
12:00 a.m. You must set the clock if you want to use the Delay Brew feature.
USING THE BREW LATER FUNCTION
• To set Delay Brew, press the BREW LATER Button. Using the HR and MIN Buttons select the desired
delay brew time.
• To activate the BREW LATER cycle, press the BREW LATER Button once delay brew time is set.
• To check the programmed time for delay brew, press the BREW LATER Button, the programmed time
will appear on the LCD Screen.
• To switch back to clock, you can press the Brew/Off Button and the screen will switch back.
ADDING WATER AND COFFEE
• Once coffee maker is plugged in and clock is set, open the Brew Basket by swinging it all the way
to the left. Place disposable #4 cone-shaped filter into the Removable Cone Style Filter Basket,
add coffee and swing Brew Basket all the way to the right to secure in place. (See the Suggested
Coffee Measurement Chart.)
• Fill the Glass Carafe with cold fresh water to the desired capacity. For easy and accurate filling, the
water markings on the Glass Carafe and on the Water Window show the amount of water needed to
make the corresponding desired number of cups.
• Do not fill past the “10 cup line” or water will flow out of the overfill hole in the back of
the coffee maker.
• Place the Glass Carafe on the Warming Plate.
• The amount of coffee brewed will always be slightly less than the amount of water poured in the
Water Reservoir. This is due to the minimum absorption of water by the coffee grounds.
NOTE:
Make sure the Glass Carafe is fully placed on the Warming Plate or the water and the grounds
will overflow from the Filter Basket. An overflow may cause personal injury or damage to property.
