4
INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your barbecue and causing injury
to yourself and to property.
1. Assemble the barbecue following the assembly instructions carefully.
2. Connect the gas hose to the barbecue. Connect the regulator to the hose.
3. Connect the regulator to the cylinder valve following the regulator instructions supplied with
the regulator.
4.
Turn all of the control knobs to the ‘OFF’ position before turning on the gas supply to the
appliance.
5. Operate the regulator in accordance with the instructions supplied with the regulator.
LIGHTING YOUR BARBECUE
LIGHTING YOUR BARBECUE
Lighting Instructions:
1. Connect the gas cylinder to the barbecue following the instructions supplied with the
regulator.
2.
Turn all the control knobs to the ‘OFF’ position.
3.
Turn ‘ON’ the gas supply at the cylinder or regulator switch following the regulator
connection and operating instructions. Check with the use of soapy water for any gas
leakage between the bottle and the regulator and the gas valve. Any leakage will show as
bubbles in the area of the leak. If leak is found do not use the barbecue. Consult your gas
or barbecue supplier for advice.
4. To light the left hand burner, Push down the left hand control knob and keep pressing
whilst turning anti-
clockwise to the “Full rate” position whilst press the ignition button sited
between the two knobs up to four times in rapid succession. This will light the left hand
burner.If not please repeat this process.
5.
If the burner has not lit after two attempts, turn ‘OFF’ the gas tap and wait 5 minutes
before retrying the ignition sequence.
6. If the burner does not stay alight, please repeat step 4.
7. When the burner is lit. Adjust the heat by turning the knob to the High/Low position.
8. To light the right hand burner, Push down the right hand control knob and keep pressing
whilst turning anti-
clockwise to the “Full rate” position whilst press the ignition button sited
between the two konbs up to four times in rapid succession. This will light the right hand
burner. If not please repeat this process.
9. If the burner has not lit after two attem
pts, turn ‘OFF’ the gas tap and wait 5 minutes
before retrying the ignition sequence.
10. If the burner does not stay alight, please repeat step 8.
11. When the burner is lit. Adjust the heat by turning the knob to the High/Low position.
12.
To turn ‘OFF’ the barbecue, turn the cylinder valve or regulator switch to the ‘OFF’
position by following the regulator instructions, turn all of the control knobs on the
appliance clockwise to the “OFF” position when the flame have extinguished.
Warning:
If any burner fails to ignite, turn the control knob off (clockwise) and also turn the
cylinder valve off. Wait five minutes before attempting to relight with ignition sequence.
After use,
close the gas supply by either turning ‘OFF’ the switch on the regulator or turning
‘OFF’ the cylinder valve.
In the event of light back whilst the appliance is in use. Turn all the controls, cylinder valve and
regulator switch to the ‘OFF’ position. Wait 5 minutes before attempting to relight the appliance.
