34
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
Gateway Not Found
If no device is found after the initial 120 second time-out, the WPS/Strength LED bar shifts
from the blinking Green to solid Red.
LED bar remains red for another 60 seconds, then revert to the No Internet failure status.
If pairing is accomplished, LED bar will change to reflect Gateway status.
Solid Red
After pairing, follow the Gateway Status
After the pairing is complete (60 seconds after the signal strength has been displayed), the
light bar indication shall follow the Gateway status as described on the Light Bar tab in this
spreadsheet.
If the mesh is connected via Ethernet connection, if boot up successfully, the light bar
indication shall follow the Gateway status as described on the Light Bar tab in this
spreadsheet.
After 60
seconds, Cyan
or Red, or Off
Lost Control plane but data plane is still connected
Regardless of what stage the mesh unit is in. If the control plane is loss but the data plane is still
in connection. Then flash the LED to red for 15 seconds, after that return the LED to cyan
Flash LED to
red for 15
seconds, then
revert to Cyan
Wall Mount Template
Inside the giftbox of the BLAST u4/u4m, a printed wall mount template is included. This
template is scaled to size and should be used when marking the hole locations for the wall
mount option. The figure below is a representative example of the template but should not
be used as it is not scaled appropriately.
For additional information, refer to
Wall Mounting the u4/u4m
) located in the
Installation chapter of this guide.
Summary of Contents for GigaSpire BLAST U4
Page 1: ...GigaSpire BLAST Installation Guide Model u4 u4m June 2021 Part 220 01192 Rev 10...
Page 2: ......
Page 28: ...28 Proprietary Information Not for use or disclosure except by written agreement with Calix...
Page 36: ...36 Proprietary Information Not for use or disclosure except by written agreement with Calix...
