Calira EVS 36/20-DS/IU, Operating And Installation Instructions, Page: 34 / 76

34
Selector switch – battery type
On delivery, the device is set for operation with liquid electro-
lyte batteries (F). Change the setting of the selector switch to
gel (G) if an AGM / gel-battery is used (fig. 4, pos. 5).
F G
F = liquid electrolyte battery
G = AGM / gel-battery
Fig. 17: Selector switch – battery type
Mains connection
Equalise the potential (fig. 4, pos. 3) between the device and
the camper or caravan. Use a green/yellow cable with a mini-
mum cross-section of 4 mm². The potential equalisation does
not replace the protective conductor in the mains cable.
green/yellow min. 4 mm²
connect to a conducting
part of the mobile home
or the caravan
Potentialausgleich
Fig. 18: Mains connection / potential equalisation
Connect the 230 V output (fig. 4, pos. 2) of the
power supply with the on-board distribution of your
mobile home or caravan. Connect the green/yellow
cable to the earth circuit! The 230 V circuit breaker
of the electric supply serves as mains protection,
and is connected directly on the input side to supply
socket of the mobile home or caravan.
Fig. 19: 230 V output
Check that all the connections are firm and secure.
As the last step, make the mains connection via the
female connector of the mains cable (fig. 4, pos. 1).
The socket on the device is provided with a locking.
When connecting the plug, make sure that the
locking engages. In order to remove the plug, the
locking must be released by lightly raising its wing.
Fig. 20: 230 V input