2
1
4
3
7
5
6
8
9
5
1
2
3
4
6
page 7
Diagram 2
Position the gas valve (2) with the pre-assembled hose, as shown, from behind into the two
big holes (4) of the front panel (7), so that the cam (3) will fit into the lower small hole on the front
panel. Screw the thick short crossbar screw (5) into the upper small hole and pull the valve hard
on to the front panel. Then stick the ignition push-button (6) into the hole (8) on the right of the
valve and screw it on with the big nut (9) from the back on to the front panel. Press the control-
knobs (10) on the valves.
Diagram 3
For this step of the assembly, you need the front panel (5) with the already screwed on valve
and ignitor as well as the two bottom casting holders (1 & 4). First screw the two bottom casting
holders with screws (2), Washers and nuts (3) to the legs at the front and at the back, but do
not pull the screws on too hard yet. Then attach the front panel with a self-tapping screw (6)
from the front on to the left and right of the bottom casting holders.
10
