![background image](http://html1.mh-extra.com/html/california-instruments/2001rp/2001rp_user-and-programming-manual_3444999023.webp)
User and Programming Manual - Rev N
3.3 Input Voltage Range Selection
WARNING:
Voltages up to 350 VDC and 300 VAC are present in certain sections of
this power source. This equipment generates potentially lethal
voltages.
DEATH:
On contact may result if personnel fail to observe safety precautions.
Do not touch electric circuits when power is applied. Servicing should
only be performed by trained personnel.
The input voltage range is configured by moving one wire and relocating jumpers at W1-W4.
See Figure 3-3 or Figure 3-4 for the location of the A6 board (DC Supply) where the jumpers
and input wires are located.
14 April
2007
2001RP
Summary of Contents for 2001RP
