CF-TO-VE402-7_ii_190425
Pg 1
Arpeggio
®
CF-TO-VE402-7, TS-E4-E4 & D-E4-E4
In-Wall Vessel Lavatory Faucet / Tub Spout
Installation Instructions
1
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:
Recommended Supply Pressure: 20 to 70 psi
*†
Maximum Flow Rate: 1.2 gpm for Lavatory Vessel, 10 gpm for Tub Spout
*
Operating pressures between hot and cold supplies should vary no more than 30 psi.
†
If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (PRV).
INSTALLING SPOUT
•
Prior to installing faucet trim in-wall vessel rough
VALVE (
1
), must be properly installed and wall
surface must be completely finished
NOTE:
Recommended through-hole size shall be
Ø
1-1/4
”
•
Apply thread sealant to both threaded ends of
NIPPLE (
2
), not supplied, and tighten into center
outlet of VALVE (
1
)
•
Tighten QUICK CONNECT (
3
) onto end of
NIPPLE (
2
)
using ½” open
-end wrench
•
Confirm QUICK CONNECT (
3
) is protruding from
finished wall the correct amount with table given
Model
MIN “A”
MAX “A”
CF-TO-VE402-7
1-
9/16”
1-
3/4”
TS-E4-E4
1-
9/16”
1-
3/4”
D-E4-E4
1-
9/16”
1-
3/4”
•
Slide SPOUT ESCUTCHEON (
4
) onto QUICK
CONNECT (
3
)
IMPORTANT:
To prevent damage to internal o-ring on SPOUT (
5
),
QUICK CONNECT (
3
)
MUST
be free of any dirt and/or debris
•
Slide SPOUT (
5
) onto QUICK CONNECT (
3
) and
tighten both SETSCREW (
5a
) on bottom side of
SPOUT (
5
)
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
BY A LICENSED PROFESSIONAL
NOTE:
Spout installation shown with lavatory
vessel valve, Tub Spout installation is the same
WARNING:
Dimension “A” must be met to prevent water damage
Tighten with
½” open
-end wrench
A
Quick Connect
A
3
4
5a
5
Ø1-1/4
”
1
2
3
