"A"
Escutcheon
Sink/
Countertop
Spacer Cup
Fiber Washer
Bottom Nut
Valve
OUTLET
INLET
P2
Install valve bodies
(See Fig. 1 & 3)
:
7202 Series
"A" = 3/4"
7302 Series
"A" = 1"
Fig. 3
NOTE:
Hot & cold valves are labeled:
RED
= hot &
BLUE
= cold.
-Remove top nut and discard.
-Turn bottom nut with fiber washer down the valve until it stops.
-Place spacer cup onto valve oriented correctly as shown.
-Insert valve through hole from below.
-Attach and thread escutcheon onto threads below stem and
adjust valve to scheduled height "A".
-Place handle onto stem allowing minimal gap between escutcheon and
handle. Tighten setscrews with Allen key provided.
-Align handle in desired position and tighten the bottom nut to secure valve.
NOTE: Align square escutcheon on 7202 Series prior to securing valve.
Piping:
3
2
-Use rigid copper piping (not included) to connect hot & cold valves to tee & water supply
(See Fig. 1).
Flexible hoses are not recommended for the following reasons:
1. Hoses may be inaccessible and require occasional replacement;
2. Some trim installations require escutcheon to hold valve in place.
WARNING: To prevent damage to valve all soldering shall be performed before attaching fitting directly to valve.
Any additional soldering should be performed at least 6" away from valve ports.
RT_7208_ii_101220
