CD PLAYER
Continued
6
SKIP/REVERSE
When REV is pressed from the Stop mode, the program will go back one track and begin playing
the last track on the CD. When pressed from Play or Pause mode, the program will go back to the
beginning of the track which was already playing. Continuing to press REV will step back one
track at a time.
7
REPEAT/ENTER
Pressing Repeat once will continuously replay the selected track. Pressing it twice will replay all
tracks continuously. Pressing Repeat a third time will clear the settings.
8
SHUFFLE
Pressing Shuffle from Stop, Play or Pause will result in random selection of tracks and begin
playing continuously. Pressing Shuffle again will clear the program.
9
PROGRAM
In Stop mode, press Program and observe “P 1: ” on the LCD. Press FWD and see “1:01”, press FWD
again and see “1 :02”. Press enter and “2” will appear in the upper right of the LCD. Press FWD three
more times and see “1:05”. Press Enter and see “5” added to the LCD. Press play and the second track
will play, then advance to track 5. After playing all the selected tracks the program advances to the
end of the CD. Pressing Play will repeat the program. To clear the program in the Stop mode, just
press Program. Individual selections can be cleared while they are playing by pressing Program.
This will not affect other selected tracks.
10
EJECT
Pressing Eject from any mode will advance the program to the last track on the CD and eject the
CD. “NO dISC” will appear on the LCD.
NOTE:
The CD player is capable of playing CD, CD-R and CD-RW discs, however due to the condition of the disc or the original it
was copied from some discs may not play.
9
10
Powered Companion Speaker PA919PS
The Powered Companion PA has the same amplifier, power supply and speaker compliment as the full featured PowerPro PA919. It
does not have the mixer panel because it can be controlled by the PowerPro PA919.
With the integral 16-channel selectable wireless UHF receiver, it can function as a stand alone PA speaker when using a Q319 Handheld
microphone or the M319 Beltpack transmitter with a NM-316, OE-316, LM-316, CM-316 or HBM-316 microphone. Although there
are 5 LEDs on the front of the PA919PS only 3 lights function on this unit because there is only one receiver. The red LED indicates
RF, the amber LED is for audio, and the green LED indicates power On.
Full Wireless Operation
As the transmitter on the PA919 is preset on channel 13, the receiver of the PA919PS is also set on 13. Any audio from the PA919
can be transmitted to the PA919PS without wiring. There is no limit on the number of PA919PS speakers that can be used with the
PA919 within a range of 150 feet.
Audio Line Buss
When linking one or two PA919PS speakers to the PowerPro PA919 via audio line, the PSC-50 XLR cable is connected to Audio Line
Out XLR connector on the PA919. The other end is connected to Line In XLR on the Powered Companion Speaker.
The Master Volume Control on the Audio Line panel of the master will adjust the PowerPro PA919 as well as all the Powered or
Passive Companion Speakers, however the loudness needs to be adjusted via the Master Volume Control on the PA919PS as well.
Note:
The mute switch on the PA919 will silence all speakers connected to it by cable. However in the full wireless mode using the
transmitter of the PowerPro the mute will have no effect.
califone_919_manual_rev1.indd 12-13
6/22/09 1:16 PM
