B
A
1 3 5 7
5
2 4 6 8
7
4
8
EN-3
53mm
182mm
3
2
182mm
53mm
1
2
1
3
4
Bend these
claws, if necessay
release screw and
bracket
ISO CONNECTOR
RCA Jack Line Out:
Red (right) White (left)
CONNECTOR A
4. 1V
5. AUTO ANTENNA OUTPUT
7. +1V (TO IGNITION KEY)
8. GROUND
Note:
(connector A no. 7) wire must be connected by car ignition key in order to avoid that car battery
becomes weak when the car will be not used for long period.
CONNECTOR B
1. REAR RIGHT SPEAKER (+)
. REAR RIGHT SPEAKER (-)
3. FRONT RIGHT SPEAKER (+)
4. FRONT RIGHT SPEAKER (-)
5. FRONT LEFT SPEAKER (+)
6. FRONT LEFT SPEAKER (-)
7. REAR LEFT SPEAKER (+)
8. REAR LEFT SPEAKER (-)
Maintenance
FUSE REPLACEMENT
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after the
replacement, there may be an internal malfunction. In this case, consult your nearest repairing center
Warning
Use the specified amperage fuse for each lead. Use of a higher amperage fuse may cause serious
damage.
INSTALLATION
PRECAUTIONS
•
Choose the mounting location carefully so that the unit will not interfere with the normal driving functions
of the driver.
•
Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight
or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration.
•
Use only the supplied mounting hardware for a safe and secure installation.
•
Be sure to remove the front panel before installing the unit.
NOTE :
Inclination angle for car radio installation must not
exceed 30˚ otherwise the front panel will not open.
Note:
Keep the release key in the safe place as you may need it in future to remove the unit from the car.
ANTENNA
CONNECTOR
L (WHITE) R(RED)
LINE OUT
ISO CONNECTOR
