5
The following instructions guide you step
by step through the initial setup of the
navigation system.
Firstly, remove the foil for protecting the
device during transportation from the
display.
Switch on the navigation system.
Set the battery switch (15) on the bottom
of the device to the ON position.
Attention: Always leave the battery switch
on the ON position, unless you want to
perform a new reinstallation. If the switch
is set to the OFF position, all data will be
lost and you will have to perform the initial
installation again.
The initial installation of the navigation
system is started automatically. The brand
logo appears and after a few seconds
your device displays the application
screen.
Date and time are set by means of the
Setting button (4) and the date/time
control button. Set the applicable time
zone, if available.
Attention: According to the charging
status of the installed battery it is
necessary for the device to be charged
before the initial setup can be performed.
Charging the Battery of the Navigation
System
Note: When charging the battery, please
ensure that the battery switch is set to
the ON position. During charging the
battery charge indicator lights red.
You have different possibilities to charge
the battery of your navigation system:
• By means of the AC adaptor.
• By means of the car charger.
• The battery charge indicator lights red
until the navigation system is fully
charged, then the battery indicator turns
green. Do not interrupt the charging
process before the battery is fully
charged, which will take a few hours.
• Note: You can use the navigation
system during the charging process,
but the power supply must not be
interrupted during initial setup.
• Leave the AC adaptor connected to
the navigation system until the battery
is fully charged.
• You can leave the AC adaptor
connected, which is very convenient
for continuous operation. Please note
that the AC adaptor also consumes
power even if it is not charging the
battery of the navigation system.
Slide the connector converter into the
guide on the right side of the AC adaptor.
Plug the AC adaptor (2) in an outlet that
is easily accessible.
Connect the cable of the AC adaptor (1)
to the AC adaptor port of the navigation
system.
Working with Memory Cards
Your navigation system supports SD
(Secure Digital) memory cards.
Inserting memory cards:
1.Carefully take the memory card out of
its packaging (if included). Make sure
not to touch or dirty the contacts.
2. Push the memory card carefully into
the card slot. The labelled side of the
memory card must point upwards. The
memory card should slightly lock in
place.
Removing Memory Cards
• Do not remove the memory card while
it is accessed. This could result in loss
of data.
1. To remove the card lightly press it into
the device the upper edge until it ejects.
2. Pull out the card without touching the
contacts.
3. Store the memory card in the packaging
or in another safe place.
• Memory cards are very fragile. Take
care not to dirty the contacts and not
to force the card.
INSTALLATION
2
1
