Smart Display SD3
3
|
• simultaneous visualisation of collector and store
temperature as well as heat quantity
• one 6-digit and two 4-digit 7-segment LED dis
-
plays
1. Installation
The device must only be located in dry interior
rooms. It is not suitable for installation in hazardous
locations and should be protected from electroma-
gnetic fields.
1.1 Mounting
Wall mounting
The wall mounting of the SD3 has to be carried out using
the enclosed high-grade steel bracket.
1. Hold bracket to the desired place on the wall. Mark
drilling holes on the wall and drill holes with a 6 mm
drill.
2. Insert dowels and attach the bracket to the wall with
the screws (accessory bag).
Place the SD3 in the middle of the bracket.
Use as table-top unit
Insert wooden rod into the lower hole on the rear side of
the housing.
The SD3 can now be placed to the desired place.
wooden rod
• simple connection via
iSolar
VBus
®
• outstanding design
• power supply via
iSolar
VBus
®
2. Connection and commissioning
The
iSolar
Smart Display SD3 is designed for simple con-
nection to
iSolar
controllers via the
iSolar
VBus
®
. The bus
cable can be extended with a two-wire cable (bell wire).
The cable carries low voltage and must not run together in
a cable conduit with cables carrying a higher voltage than
24
V (please pay attention to the valid local regulations
such as VDE regulations for Germany). The cross section
must be at least 0
.
5 mm
2
and the cable can be extended up
to
165
ft.
in the case of a single connection.
Note:
Protect susceptible furniture surfaces against scratches.
