12
8. INITIAL PROGRAMMING MODE AND PROGRAMMING MODE
A touch to any element "ON" key
or to the “FAN” key
will activate “Initial
Programming Mode”. Initial Programming Mode is active for a period of 10 seconds from that
first touch. Once a level has been selected, the Programming Mode is active for an additional 5
seconds period from the last key touched. When in Programming and Initial Programming
Modes, the LED under the “ON/ADJUST” key
will flash.
9. INDIVIDUAL BURNER FUNCTION CONTROL
Each burner has an “ON/ADJUST” key
with an LED in the center, an ‘OFF’ key
, a
seven segment digit display representing the power setting and 3 round LED's to represent ¼; ½;
¾ heat settings beside each digit. The dual burner has a dual toggle key , beneath which two
LED’s indicate the dual or single state of the burner. Hot light indicators are located beside the
burners and are independently driven from the control. There is one centralized power
adjustment with the keys 0, L, 1, 2, 3, 4, 5, 6, 7, 8, 9, and H.
10. SELECTING AN ELEMENT
To select an element, the corresponding on/adjust symbol
must be touched. A touch to that
symbol will cause the selected element to enter “Initial programming mode”, the corresponding
LED digit to display a “0” and flash the "ON" key LED. If a power level
or timer key is
not touched for an uninterrupted period of 10 seconds, the programming attempt will be
canceled. A touch of any other element symbol
will cause that element to be selected while
the previous selection is cancelled.
11. SELECTING A POWER LEVEL
After Selecting an Element
and entering Programming Mode, you have 10 seconds to select a
digit
that represents the desired power setting. A touch to ‘0’ will display ‘0’ for the 5
seconds of Programming Mode, following the 5 seconds, if no other power setting has been
selected, the burner will turn off. After selecting L, 1, 2, 3, 4, 5, 6, 7, 8, 9, or H the burner will
remain in Programming Mode for an additional 5 seconds in case you would like to select a
different setting or a Detailed Power Level.
12. SELECTING DETAILED POWER
While in Programming Mode of an element and after having selected a power level, if the same
power level key is touched again the selected element will enter detail mode. Multiple touches
will turn the “detail” setting up and down with the following pattern: ¼, ½, ¾, back to ½, ¼,
none, back to ¼…etc. This provides a total of 44 settings per burner so you can find that perfect
simmer or melted chocolate setting.
13. TURNING ELEMENTS OFF (4 methods)
a) Touching the OFF key
for the corresponding element will turn off the selected element.
b) Selecting the ‘0’ and no subsequent power setting for five seconds, while in programming
mode of an element, will turn off the selected element.
Summary of Contents for CMT364
Page 2: ......
