26 — ElectriCalc Pro
Preference Settings
Your calculator has the following Pref-
erence Settings that you can access
and change at any time.
Reach the Preference Function by
pressing [Set] [÷]. Then, to access
each category, press the [÷] key until
the desired setting is reached.
Within
each category, press the [+] or [-] keys
to toggle between individual selections
(note: the [+] will advance, the [-] will
back-up).
You can change these settings at any
time by repeating the above, and set-
ting in a new preference.
NOTE: To
clear preferences, you must either reset
using keystrokes below, or perform an
All-Clear ([Set] [x]).
The Preference Settings are (default
settings shown first):
To Set 1999 or 1996 NEC Code:
[Set] [÷]
(1st press of [÷])
CODE 99
[+]
CODE 96
To Set Ambient Temp. to °C or °F:
[÷]
(2nd press of [÷])
AMB° 30 °C
[+]
AMB° 86 °F
To Set Length to Feet or Meter:
[÷]
(3rd press of [÷])
FEET 1.
[+]
MET 1.
5060-UG-B-Composite 4/4/03 12:37 PM Page 28
