Regulatory Information
Human Exposure Compliance Statement Pursuant to 47 CFR § 15.247 (i) of the FCC Rules
and Regulations, personal communications services (PCS) equipment is subject to the
radio frequency radiation exposure requirements specified in § 1.1307(b), § 2.1091 and §
2.1093, as appropriate.
CalAmp Wireless Networks Inc. certifies that it has determined that the STAG09XT
complies with the RF hazard requirements applicable to broadband PCS equipment
operating under the authority of 47 CFR Part 15, Subpart C of the FCC Rules and
Regulations. This determination is dependent upon installation, operation and use of
the equipment in accordance with all instructions provided.
FCC Rules and Industry Canada (IC) regulatory information Compliance Statement (Part
15.19) The equipment device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received including
interference that may cause undesired operation. Warning (Part 15.21) Changes or
modifications not expressly approved by Calamp Wireless Networks could void the
user’s authority to operate the equipment. Manufacturer is not responsible for any radio
or TV interference caused by unauthorized modifications to this equipment. Compliance
Statement (Part 15.105(b)) Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—
Reorient or relocate the
receiving antenna.
—
Increase the separation between the equipment and receiver.
—
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—
Consult the dealer or an experienced radio/TV technician for
help. This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device. Le présent appareil est conforme aux
CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.