10/12/13
LMU-3000 Hardware & Installation Guide - PULS Wiki
https://puls.calamp.com/wiki/LMU-3000_Hardware_%26_Installation_Guide
22/33
connection cable.
The AT Command to check vehicle detection status.
ATIV
The vehicle detection complete response will look like:
-Vehicle Detection-
Detection Complete
VIN: <Vehicle Vin Number>
OBDII Protocol:5
Params:0,1,4,7,8,11,12
Indicators:0(000000000011),1(11111111111)
The SMS command to check vehicle detection status:
!VV
The vehicle detection complete response will look like:
-Veh Det-
Yes
VIN:<Vehicle Vin Number>
Proto:5
Params:0,1,4,7,8,11,12
Inds:0(000000000011),1(11111111111)
DTCs Cnt:7
Flt Mtch:1
4. Once the vehicle detection has completed the vehicle ignition can then be turned off.
5.3 Installation Verification
In many cases it is desirable to verify that an installed LMU-3000™ is working properly. That is, installers
should verify that the GPS and communications functions of the LMU-3000™ are working properly before
departing the installation site. In more robust cases, some key configuration settings such as the Inbound
Address and URL should also be verified.
Note that these processes are all based on issuing AT Commands to the LMU-3000™. It is expected that
installers will have access to a serial port expansion cable and a laptop or PDA capable of a terminal
connection. Alternatively, an SMS message can be sent to an LMU-3000™ to obtain its current status.
