2010 Barbecue Grills
LTR20101038, Rev. A
Installation /
Assemb
ly
www.calflamebbq.com
9
Installing Grills in
Barbecue Islands
You will need a second person to help you to
avoid damaging the grill, the transformer, or
your barbecue island .
Before installing a grill or side burner in any island
or cut out, make sure that the opening is not bigger
than the outside frame of the grill unit. The grill
should rest on the lip of the frame. For drop-in
accessories, adequate cross ventilation must be
designed into enclosure to ensure the drop-in grill
or side burner does not become overheated.
Pay careful attention to the location of gas lines.
Gas lines should be routed away from sources of
heat and should make as few bends as possible.
Check to see if gas line connections will be accessible
when grill is installed.
If gas line connections are not easily accessible
•
when the grill is installed, support the grill
above counter level and attach the gas lines to
the grill. When the gas connections are made,
slide the grill into the cut out.
If gas line connections are accessible when the
•
grill is installed, slide the grill into the cut out
and then attach the gas lines.
Be very careful not to kink gas lines when lowering
the grill or side burner into the cut out.
Keep your fingers away from where the grill will be
supported on counter. Your fingers could become
trapped and serious injury could occur.
Check to make sure the grill is level and is supported
around the entire outside edge. If the grill is not
level or is unstable, use non-combustible shims
under the outside lip to stabilize it.
Perform the leak test procedure as described earlier
in this manual.
Installing the Rotisserie
Attach the two brackets to the sides of the grill, one
on each side, using two screws as shown below.
Slide the rotis motor on one of the brackets as
shown below. The rotis motor will work on either
side of the grill.
Remove the metal cap protecting the outlet that
provides power for the rotis motor. Plug in the motor
cord and screw on the retainer nut to keep the plug
in place.
Summary of Contents for BBQ08873P
Page 1: ...LTR20101038 Rev A 4 30 10...