Preparing the Emfit
This is a supplementary guide to the manufacturer’s User Manual. Please read both before installing and using the Cair Emfit.
The Cair Emfit consists of the main controller, Cair transmitter, bed pad, power supply and mounting tools. Firstly, connect the power
cable, Cair transmitter and the bed pad/sensor into the main unit. Once all components are connected, the unit can be turned on by
holding down the small orange switch until a beep is heard and the blue LED flashes. The turn off the Emfit, hold down the orange
switch until a beep is heard.
Note: When the unit is turned on, there will be a continuous warning beep if the bed pad has not been connected.
Important: Although the device can operate on battery power, it is recommended that the device is always connected to a power
supply.
Positioning the Emfit Bed Pad
There are several methods of positioning the bed pad.
These are indicated on the pad itself, and further information can be found in the user’s manual
Sensitivity Settings
There are several sensitivity settings which can be set using the internal dip switch. Please refer to the user’s manual for further
information.
Testing the Emfit
To test the Emfit, ensure the device has been switched on and the bed pad and Cair transmitter have been connected to the main
unit. Carefully remove the backplate of the main controller. Place weight on the bed sensor for around 60 seconds, the two LEDs will
flash during this period, once the LEDs flash in sync continuously, you can now simulate movement across the bed pad using your
fingerprints for around 13 seconds. The sounder will alarm to confirm the test has been successful.
Assigning the Emfit to a Notifier or other telecare system
1.
Ensure the Emfit is switched on.
2.
Prepare the Notifier/other system by entering registration mode.
3.
Activate the Emfit by using a paperclip/suitable tool to activate the test button on the main device.
4.
The Notifier/other system should acknowledge the new device.
Programming
Guide
Page 2
V 1.0
Sensor Pad
Control Unit
Cair Wireless
Transmitter
Rail Mount
Wall Mount
Power / Transmitter / Sensor
Under-mattress sensor
Rail mountable
