Copies of the I/B. Please reproduce them without any
changes except under special instruction from
Team
International USA
. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
6
CMN KS 36731 - 111215
Assembly page 6/12
Fax +1 305 430 9692
•
Place the bracket and socket assembly on the exposed portion of the
screw, and then slide the assembly downward to let the screw go into
the slot.
•
Tighten both screws (but not too much) to secure the assembly in place.
HOW TO USE YOUR VACUUM CLEANER
•
Push the On/off switch (3) forward to start vacuuming. The vacuum
cleaner will pick up dirt from any surface.
•
If you find the suction power is becoming weak or if appliance stops,
then you need to recharge the unit again.
•
For vacuuming dirt or dust from small gaps/cracks or other places
difficult to reach, it is recommended to use the crevice tool (14) for best
results. Just insert the crevice tool in front of the dust compartment (8).
•
For vacuuming liquids from a smooth floor, it is best to use the wet nozzle
(liquid scraper) accessory (13). Just insert the nozzle in front of the dust
compartment (8). Make sure the dust compartment is empty prior to
vacuuming liquids.
•
Verify regularly the dust level by holding the appliance vertically, the
nozzle towards the ground. Make sure to empty the dust compartment
before dust and debris reach the maximum level indicated.
•
Use with the long Tube: put the two parts together and attach the long
tube to the vacuum cleaner. Use the long tube for difficult to reach
areas like an air conditioner (Fig. 2)
•
Please empty the dust compartment after each use. For this, detach the
dust compartment (8) from the main housing, by pressing the release
button (5), and remove the filter (6) and filter bracket (7) from the dust
compartment. Dry the compartment and the filter thoroughly before
reassembling the unit. See below for complete details.
