FOR WARRANTY ISSUES OR QUESTIONS, CONTACT CAHABA AT (866) 837-2550.
©2018 CAHABA. ALL RIGHTS RESERVED.
4
ENGINEERED QUARTZ SINK
Topmount Installation Instructions
TOPMOUNT - PREPARE THE COUNTERTOP
1.
Position the template (provided with your sink) front to rear so the sink
will not interfere with the cabinet; secure with tape.
2.
Trace the template and remove. Dry fit the sink to verify the
measurements.
3.
Following the countertop manufacturer’s instructions, carefully cut the
countertop on the inside of the traced line.
4.
Locate and drill the mounting holes, following the countertop
manufacturer’s instructions. Holes should allow even spacing of
mounting brackets around the sink.
X
IMPORTANT: The cabinet must be installed, secured, plumb, and level
BEFORE installing the sink.
INSTALL THE COUNTERTOP
1.
Punch out faucet holes. Faucet holes can be identified by the faucet
hole emboss on the underside of the sink and the corresponding yellow
labels located on the top surface. Before punching the holes please
verify that the circular labels are properly centered over the faucet
emboss. The faucet hole should be carefully penetrated FROM ABOVE
THE SINK using chisel or screw driver and tapping lightly on the circular
labels. If necessary the hole can been enlarged using a metal hole saw,
a jigsaw with a metal cutting blade
2.
Apply a narrow bead of silicone adhesive sealant evenly all around the
top edge of the countertop. CAUTION: DO NOT USE EPOXY TO SEAL
SINK.
3.
Position and align the sink over the countertop opening. Carefully
lower the sink into the cutout in the countertop. Press silicone onto
countertop.
4.
From the underside - place the clamp in the center along each side and
hand tighten to hold sink in place. Fasten the remaining clamps along
the edges and space them approximately 3 in. from each end, and
equally along the front, back and sides. For countertops thicker than 3/4
in., space them up to 1-1/2 in. apart.
5.
Tighten fasteners until mounting brackets are snug against sink. Check
alignment of sink to the countertop opening.
6.
Tighten down fasteners evenly. Be careful not to over-tighten.
7.
Immediately remove excess sealant.
X
IMPORTANT: Cahaba is not responsible for sink or countertop if damaged
during installation. Be sure to inspect the sink for damage prior to
beginning installation.
OUTLINE FOR SINK CUTOUT
APPLY SILICONE SEALANT AFTER CLEANING THE
SINK EDGE AND COUNTERTOP
CAREFULLY LOWER THE SINK INTO THE
CUTOUT ON THE COUNTERTOP
MOUNTING
BRACKET
FASTENER
SILICONE
CAULK
COUNTERTOP
SINK
