747DC-WCS White/Blanc/Blanco 12V
747DC-BCS Black/Noir/Negro 12V
747CA24-WCS White/Blanc/Blanco 24V
747CA24-BCS Black/Noir/Negro 24V
757DC-WCS White/Blanc/Blanco 12V
757DC-BCS
Black/Noir/Negro 12V
Caframo Limited
501273 Grey Road 1
Georgian Bluffs, Ontario, Canada, N0H 2T0
1-800-567-3556/ 519-534-1080
Fax: 519-534-1088
www.caframo.com
Ultimate
747MN001 Rev01
Limited Warranty/ Garantie limitée/
Garantía limitada
www.caframo.com/warranty
Warranty
Limited 1-year warranty against defects in
workmanship and/or materials. Caframo warranty
covers repair or replacement cost of fan only and
does not cover incidental or consequential damages
or costs.
Garantie
Garantie limitée de 1 an contre les défauts de
fabrication et de matériaux. La garantie de Caframo
couvre uniquement les frais de réparation ou de
remplacement du ventilateur et ne couvre pas les
dommages ou les coûts accessoires ou indirects.
Garantía
Garantía limitada por 1 año contra defectos de mano
de obra y/o materiales. La garantía de Caframo
cubre solo la reparación o el costo de reemplazo
del ventilador. La garantía no cubre daños costos
incidentals o indirectos.
DC CABIN FAN
VENTILATEUR CABINE C.C.
ABANICO DE CABINA CC
Thank you for purchasing a Caframo Ultimate Cabin Fan
Features
Superior Air
fl
ow, 2 Speeds, FingerSafe
TM
Blade, Ultra Quiet, Low Power Draw
Installation
For Permanent base (747 or 757) (see Figure 1-A):
1.
Unscrew triangular knob (a) and remove bolt (b) from fan assembly.
2.
Separate fan from suction cup post (c).
3.
Feed
fl
ange base (d) over
permanent base post (e).
4.
Secure base to desired surface using two #6
fasteners (provided).
5.
Feed base nut (f) over post and tighten to
fl
ange.
6.
Connect fan to post securing with bolt and knob.
Direct wiring instructions:
Remove lighter plug using wire cutters.
Connect the smooth wire to 12 volt positive (+) and connect the
ribbed wire to negative ground. If the fan blade turns backwards
(counterclockwise), reverse the polarity (wires) to correct.
For Suction Cup base (747 only) (see Figure 1-B):
Clean glass or surface where fan is to be mounted. Moisten bottom of
suction base and press to surface.
Operation
The blade must be clear of any obstructions that would cause it to jam.
Use switch at back of fan to select low (I) or high (II) speed.
Read and Save these Instructions
Warning!
Do not position fan too close to objects that may be drawn into moving blades. Do not use outdoors.
Do not use on wet surfaces, immerse in water or allow water to drip into motor housing. Do not use if power
supply cord becomes frayed or brittle. Do not use gasoline, thinners or other harsh chemicals to clean fan.
