PROGRAMMING THE QUANTITY OF BEVERAGE IN A CUP
9
ADJUSTING THE CUP/ MUG HEIGHT
The machine can be adjusted for the use of large cups or espresso cups.
-
The machine is initially set for the use of large cups (Fig. 7).
-
For the best possible results when using espresso cups, raise the drip tray, expand the bottom
part and fix it in place by turning it clockwise (Fig. 10).
-
Reposition the drip tray and start using the espresso cups (Fig. 8).
1. Raise the lever to open the capsule compartment (Fig. 1).
2. Insert the capsule, pressing it gently into place (Fig. 2).
3. Close the lever fully (Fig. 3).
4. Place a cup or espresso cup under the dispensing spout (Fig. 7 or 8).
5
.
Turn the knob so it is aligned with warning light A or B, depending on the desired coffee
beverage.
The selected warning light (A or B) comes on and the machine beeps.
6.
Press and hold button E.
The selected warning light (A or B) flashes, while warning light D remains lit steadily.
7.
On reaching the desired amount of coffee, release the button; the machine will beep three times. Now the
button is programmed. The quantity of coffee dispensed can be programmed from a minimum of 20 up to
a maximum of 250 ml.
8. Raise the lever to eject the used capsule into the drawer (Fig. 1).
9. Close the lever (Fig. 3).
GENERAL OPERATING INDICATIONS
DESCALING SIGNAL:
•
When warning light D blink YELLOW every 5 seconds, a descaling cycle should be carried out (see
chapter on ‘Descaling’).
HEATING:
•
Warning lights A-B-C-D blink simultaneously.
WHEN THE WATER RUNS OUT DURING OPERATION:
•
The water tank is empty when indicator light D blinks RED and the appliance emits 3 beeps followed
by a single intermittent beep.
•
Fill the water tank with fresh, still water (Fig. 4).
•
Press button E. Wait for the machine to complete the priming cycle and fill with water.
•
When warning light D and the light selected by the knob (A,B or C) are lit steadily, the machine is
ready to use.
IF THE LEVER IS RAISED WHILE DISPENSING:
Raising the lever while dispensing a product (Fig. 1) may cause splashes of hot water. Danger of
scalding!
•
Warning light D blinks RED. The appliance will immediately stop dispensing.
•
Close the lever (Fig. 3).
•
Press button E to reset the alarm.
•
The appliance is ready for use again.
