ENCORE VENTI Rev. 3 2021-10
www.cafection.com 800-561-6162
78
SERVICE & INSTALLATION MANUAL for Cafection's Encore Venti
9.3
Brew Group Assembly
Removing the brew group
1. Open the brewer’s door.
2. Access Service mode by pressing the SW2 (white) button
(see section 3.6).
3. Press on the "Filter Paper Install" button (see section 6.2).
4. Wait for the brew chamber to open. Cut the filter paper with
scissors on both sides of the brew chamber.
5. Remove the coffee spout and the hose support bracket
from the right side of the brew group assembly.
6. Support the brew group assembly by holding the aluminum
frame on the right side of the brew group assembly.
7. With the left hand, slide the locking pin over to the right, and
then down.
8. Pull the brew group assembly straight outward
.
Installing the brew group
1. Make sure that the dog drive pin in the back of the brew group is at 1 o’clock.
2. Align the left edge of the brew group on the left bracket support.
3. Push the brew group back completely into the dog drive motor.
4. Slide the brew group’s retaining pin up and then left.
To clean the brew group, see section 7.8.5.
8.
7.
Pin
Dog drive
P
a
rt
s Ma
in
te
na
nc
e
