AMC HV-PANDA User’s Manual
16
3.3
Injury Precautions
This section contains the fundamental safety rules for the installation and
operation of the system in order to avoid injuries.
3.3.1
Caution
The following safety precautions must be observed during all phases of operation,
service and repair of this equipment. Failure to comply with the safety precautions or
warnings in this document violates safety standards of design, manufacture and
intended use of this equipment and may impair the built-in protections within.
CAEN ELS d.o.o. shall not be liable for user’s failure to comply with these
requirements.
To avoid electrical shock or fire hazard, do not apply a voltage to a load that is
outside the range specified for that load.
Do Not Operate Without Covers.
To avoid electric shock or fire hazard, do not operate this product with covers or
panels removed.
Do Not Operate in Wet/Damp Conditions.
To avoid electrical shock, do not operate this product in wet or damp conditions.
Do Not Operate in an Explosive Atmosphere.
To avoid injury or fire hazard, do not operate this product in an explosive
atmosphere.
Do Not Operate With Suspected Failures.
If you suspect there is damage to this product, have it inspected by qualified service
personnel.
3.4
Input Ratings
Do not use DC supply which exceeds the input voltage rating of this instrument.
MTCA standards requires a fixed DC voltage source of +12V for bulk power and +3.3V
for management power, refer to the relevant standard for further informations.
For safety reasons, the supply voltage fluctuations should not exceed above
voltage range.