Cadillac 2016 CUE, User Manual

Page: 49 / 118

Cadillac CUE Infotainment System (GMNA-Localizing-U.S/Canada-
9084922) - 2016 - CRC - 3/27/15
48 Rear Seat Infotainment
.
Press to increase the
brightness of the RSE
screen.
12.
x
(Down Arrow)
.
Press to go down a list.
13.
4
(Back)
.
Press to go back to the
previous menu.
.
Press and hold to go back
to the now playing screen.
14. MENU
.
Press to go to the menu of
the now playing screen.
15. RADIO
.
Press to scroll through the
radio sources including AM,
FM, or XM (if equipped).
To use the remote control, aim it at
the transmitter window at either
seatback console or at the second
row overhead screen and press the
buttons firmly. Direct sunlight or very
bright light could affect the ability of
the RSE transmitter to receive
signals from the remote control.
Check the batteries if the remote
control does not seem to be
working. See
“ Battery Replacement ”
later in this section. Objects
blocking the line of sight could also
affect the function of the remote
control.
Caution
Storing the remote control in a hot
area or in direct sunlight can
damage it, and the repairs will not
be covered by the warranty.
Storage in extreme cold can
weaken the batteries. Keep the
remote control stored in a cool,
dry place.
Battery Replacement
To change the remote control
batteries:
1. Insert a coin or key to pull up
the rear cover on the remote
control.
2. Replace the two AAA batteries
in the compartment.
3. Replace the battery cover.
Remove the batteries from the
remote control if it will not be used
for an extended period of time.
RSE Troubleshooting
No power : The ignition might not
be in ON/RUN or ACC/
ACCESSORY.
The picture does not fill the
screen. There are black borders
on the top and bottom or on both
sides or it looks stretched out :
Press the MENU button on the
remote control to change the display
mode setting.
In auxiliary mode, the picture
moves or scrolls :
Check the
auxiliary input connections at both
devices.
The remote control does not
work :
Check to make sure the
remote control is programmed to the
correct screen. Make sure there is
no obstruction between the remote
control and the transmitter window
and check the batteries to make
sure they are not dead or installed
incorrectly.