Entertainment
Convenience
Driver
Information
Safety &
Security
Comfort
Performance &
Maintenance
Owner
Privileges
TM
13
Refer to Owner Manual for further information.
J
Reviewed with Customer (Please Check Box)
RAINSENSE™ II WINDSHIELD
WIPERS (IF EQUIPPED) and
HEATED WASHER FLUID
(IF EQUIPPED)
The Rainsense™ II windshield
wipers use a moisture sensor to
automatically operate the wipers
when needed, depending on
driving conditions and the
sensitivity setting. If the system
is left on for long periods, an
occasional wipe may occur
without any moisture on the
windshield to indicate the system
is still activated.
The headlamps also will be turned
on automatically when the
Rainsense wipers are active.
The windshield wipers control is
located on the multifunction lever
on the left side of the steering
column.
Note:
Turn off the Rainsense wipers
before entering an automatic car wash
to prevent wiper damage.
(Heated Washer Fluid):
Slide and release this
switch to start four automatic heated wash/wipe
cycles. The first cycle may take up to 40 seconds
to occur before the washer fluid is heated. The
remaining cycles may take up to 20 seconds to
occur. The system determines the amount of fluid
and activates the wipers. Slide and release the
switch again to cancel any remaining cycles.
(Sensitivity
Setting):
Rotate the
control band up to
one of the sensitivity
levels to activate the
Rainsense function.
The wipers activate
more often as the
band is rotated
upward.
(Washer Fluid):
Push
the paddle on top of the
multifunction lever to
spray washer fluid on the
windshield.
(Low):
Rotate
the control band up
to this position to
turn the wipers on
the Low setting.
(Off):
Rotate the
control band to this
position to turn off
the wipers.
(Mist):
Rotate the
control band down to
this position to turn the
wipers on for one wipe.
(High):
Rotate the
control band
up to this
position to
turn the
wipers on the
High setting.
76884_08a_DTS_GTK_042607.qxd:DTS 2007 A 5/1/07 2:56 PM Page 15
