Congratulations
on your purchase of a high quality Cadco Commercial warming
appliance.
IMPORTANT SAFEGUARDS
1.
Read all instructions before use
.
2.
Do not touch hot surfaces! Always use hot pads or pot holder until unit cools.
3.
To protect against electrical hazards, do not immerse cord, plug or tray in
water or any other liquid.
4.
Close supervision is necessary when any appliance is used by or near
children.
5.
Unplug unit from outlet when not in use or before cleaning. Allow to cool
completely before cleaning or storing.
6.
Do not operate any appliance with a damaged cord or plug or if the appliance
malfunctions or has been damaged in any manner. Call Cadco Customer
Service at 860-738-2500 with any questions or service needs. Canadian
customers call Joicey Food Services, Ltd. in Ontario, Tel. (905) 825-9665.
7.
Do not use this appliance outdoors.
8.
Do not let cord hang over an edge of table or counter. Do not let cord touch
appliances hot surface.
9.
Do not place on or near a hot gas or electric burner, or in a heated oven.
10.
Do not use this appliance for other than intended use.
11.
Do not clean with metal scouring pads. They can scratch and ruin your finish.
12.
A fire may occur if this appliance is covered or touching flammable material,
including curtains, walls, etc., when in operation.
13.
Do not use plastic dishes or plastic wraps in warmer.
14.
Do not run the unit dry. It is designed for wet operation only.
SAVE THESE INSTRUCTIONS
IMPORTANT NOTES
1. Your unit is equipped with a grounded, current-carrying plug. This plug will
fit into any 3 pronged outlet. This is a safety feature.
2.
Electrical connection must be a proper outlet for the 3 pronged cord.
Before connecting power, make sure the voltage and frequency
correspond to the data plate on the unit, and that your electrical circuit
can handle the Amps used by the unit in addition to any other appliances
operating on the same circuit.
3. A short power cord is provided to reduce the hazards resulting from accidents
such as tripping, entanglement, etc.
-If a long cord set or extension cord is used:
(A) The marketed electrical rating of the cord set or extension cord should
be at least as great as the electrical rating of the appliance.
(B) The longer cord should be arranged so that it will not drape over the
countertop or tabletop, where it can be pulled on by children or tripped over
accidentally.
OPERATING INSTRUCTIONS
1. Plug unit into appropriate electrical outlet. (See Important Notes.)
2.
This unit is for wet operation only. Running it dry will void the warranty.
l
Add about 4 quarts of water to
inner water holder
.
There should be liquid
at least to the MIN fill line at all times during operation.
l
Do not exceed the MAX fill line in the
inner water holder
when using
well
inserts
/steam table pan(s)
l
You may use more than 4 quarts of liquid in the
inner water holder
when
NOT using
well inserts
/steam table pan(s) (EX., if keeping corn on the cob
warm or heating hot dogs directly in the
inner water holder
.)
3. If using steam table pans or
well inserts
, position them as applicable:
l
Steam table pans should be positioned so their top edges sit on the top lip
of the
inner water holder
. Use enough steam pans to cover the top of the
inner water holder so steam does not escape. Cadco warmers will handle
one full size, two half size, or three third size steam table pans.
l
If using
well inserts
, first put the
lid
on the
inner water holder
. Then
position the
well inserts
in the holes in the
lid
, and put
well covers
in place.
If
well inserts
bob in the water and do not sit firmly in place, remove some
of the water from the
inner water holder
through the
safety spigot
.
NOTE: Models DWW-2P & DWW-11 have two 9 quart well inserts = total 18 quarts.
Model DWW-3P has three 1/3 size, 5 quart, 6 deep steam pans = total 15 quarts.
5. Turn unit on by pressing the
power switch
to the On (l) position. When the
power is on, the
power switch
will light up with a green light.
6. Turn
infinite heat control knob
to 212
o
F/ high position and preheat for
approximately 10 minutes if using 4 quarts of water. (Preheat longer if using
more water.) Then set to desired heat position for holding temperature. The
infinite heat control knob
has 13 heat settings ranging from 104
o
- 212
o
F
(40
o
-100
o
C.) Each line on the control knob represents a 5
o
C increment. Use
the following chart to choose your heat setting:
40
o
C = 104
o
F 45
o
C = 113
o
F 50
o
C = 122
o
F 55
o
C = 131
o
F
60
o
C = 140
o
F 65
o
C = 149
o
F 70
o
C = 158
o
F 75
o
C = 167
o
F
80
o
C = 176
o
F 85
o
C = 185
o
F 90
o
C = 194
o
F 95
o
C = 203
o
F
100
o
C = 212
o
F
7. The
temperature light
will come on only during heat cycle, and will go out
when set heat level is attained.
inner water holder
(stainless steel)
Note: Removing the wells/steam
pans, well covers, and lids from the
DWW-3P or DWW-11 provides the
Full Size Warmer configuration.
Full Size Warmer
configuration
2
3
Model DWW-3P*
infinite
temperature
control knob
1/3 size
steam pan
(3 supplied)
clear
polycarbonate lid
(3 supplied)
power switch
safety spigot
temperature light
power
switch
temperature
light
well insert
(2 supplied)
well cover
(2 supplied)
Model DWW-11
safety
spigot
infinite
temperature
control knob
(remove to
access inner
water holder)
lid
utensil slot
(1 per lid)
*Model DWW-2P =
same as DWW-3P,
except has (2) 9 qt.
pans & lids
