INSTALLATION
NOTE TO INSTALLER
Warning
: The installer of this product must verify that
the mounting surface will safely support the combined
weight of all attached equipment and hardware.
Improper installation may cause damage or serious
injury. The included hardware is for mounting on walls
with wood stud, concrete, or concrete block
construction for a secure, stable, and reliable
mounting. If you are uncertain about the nature of
your wall, consult an expert. Please consult your
hardware or installation professional for proper
mounting to other types of walls. The supplied
hardware is not for steel. North American Cable
Equipment, Inc. will not be held liable for the improper
use or installation of this product.
1. UNPACKING and HANDLING
Each unit is shipped with all necessary mounting hardware.
Ensure that all accessories are removed from the container before discarding packing material
2. MECHANICAL
INSPECTION
Inspect the product for shipping damage. Make sure the equipment is clean and damage free.
If equipment appears to be damaged or defective please contact us at 1-610-429-1511 for
assistance.
Never use defective parts
.
3. INSTALLATION
Brick, Solid Concrete and Concrete Block Mounting
Use the
Wall Plate
(A) as a template to mark 6 hole locations on the wall. The outer holes must
fall to left and right of the two large holes in the middle of the plate. Three in the top row slots
and three more in the bottom row. Make sure these holes are level and there is at least 200mm
(7.87 inches) between any two holes. Pre-drill these holes with a 10mm masonry bit to at least
60mm (2.4 inches) in depth. Insert a
Concrete Anchor
(F) into each of these holes. Pre-drill
these holes with a 5mm (0.20 inch) flush with the concrete surface even if there is a layer of
drywall or other material in front. Attach the
Wall Plate
using 6
Lag Bolts
(E) and 6
Lag Bolt
Washers
(D).
3
