Press
to toggle the DIV setting among 1dB, 2dB, 5dB, 10dB, 20dB.
Press the
arrow keys, you can move the marker, the channel bar that the
marker located will show on the screen, as well as signal strength.
Press
to “zoom in” or “zoom out”. You can move the marker to view the channels out
of the screen. The number to display at a time depends on the screen. It is about 100
channels when zooming out to the maximum.
3.5 Tilt Measurement
In the main menu, select the TILT measurements, press
to enter.
Signal strengths of 8 channels display in the screen
synchronously. Using
toggle the DIV among 1dB, 2dB,
5dB, 10dB, 20dB. Press
to view the testing results in list
instead of graphic bar. Press
again or press
to
quit to previous menu.
In TILT mode, press
to enter the setup menu. You can
set up to 8 channels for TILT test here. Using
highlight the desired channel and press
to select. Press
to confirm after selection. Press
to view the
channel list and press
to quit to previous menu.
The max signal strength, min signal strength and their
difference display on the screen.
3.6 Trunk Voltage Measurement
In the main menu, select the “VOLTAGE” item, press
, the
meter will enter the voltage measurement mode. As shown in
below figure.
The meter will automatically identify “AC” or “DC” of the trunk
voltage, and display on the screen. The battery voltage also
display on the bottom.
Typically at the cable demarcation point outside the structure, there will be no trunk voltage.
3.7 Carrier to Noise Ratio Measurement
In the main menu, select the “C/N” item and press
to
enter the signal noise ratio measurement mode.