Cabletron Systems WPIM T1, User Manual

Page: 49 / 66

The WAN Physical Configuration Screen
WPIM-T1/DDS User’s Guide 4-3
To select the WPIM-T1/DDS you wish to configure, proceed as follows:
1. Use the arrow keys to highlight the WPIM X command field at the
bottom of the screen.
2. Use the SPACE bar to select the appropriate WPIM, then press
ENTER. The WAN Configuration screen automatically displays
unique configuration fields for the WPIM-T1/DDS as shown in
Figure 4-1 .
The WAN Physical Configuration screen displays the following fields:
WPIM 1-2 (Read-Only)
Displays configuration information for two different WPIMs.
Type (Read-Only)
Displays the type of WPIM installed. For the WPIM-T1/DDS, the Type
field displays the service selected. When T1 service is selected, T1 is
displayed. When DDS service is selected, DDS is displayed.
WPIM # (Read-Only)
Displays the number of the slot in which the WPIM resides.
Mgr Type (Selectable)
The type of protocol manager is chosen in this field. For the DDS mode of
the WPIM-T1/DDS, the available options are NONE, PPP, FR PtoMP,
FR PtoP, and HDLC. The field defaults to NONE.
Max VCs (Modifiable)
Displays the maximum number of virtual circuits (interfaces) that the
WPIM-T1/DDS may have with the protocol chosen.
Next IF (Read-Only)
Displays the next interface available to be used.
SAVE (Command)
Saves the chosen configuration.
WPIM X (Toggle)
User selects the WPIM to be configured. Once it is selected, the user can
enter the screens of the WPIM selected to modify the data.
WAN INT CONFIG (Command)
When this field is highlighted and the ENTER key is pressed, the WAN
Interface Configuration screen displays. Refer to
Section 4.2 for details.