Configuring the ELS10-27MDU
9033276
3
Configuring the ELS10-27MDU
The ELS10-27MDU may be managed by the Local Console or over the
uplink port (port 27). If using the uplink port, an IP address is required. In
the default configuration, port 27 is in the 0x01C VLAN. To Assign an IP
address to this port, type:
ipaddr [IP-ADDRESS [NETWORK-MASK]] 0x01C
Additional Commands
The ELS10-27TX User Guide details the various commands that are
available through the Local Console or management port. The following
additional commands have been added to the ELS10-27MDU:
Address Limiting
Address Limiting is the ability to configure a limit, on a per port basis, on
the number of end user devices that have connectivity from a single port.
The command for Address Limiting is part of the enable command set. To
activate Address Limiting, type:
enable [PORT-RANGE [RIP] [TransmitPacing] [ADDRESS_LIMIT]]
The default is no limit. The user can set the limit on a "per port" basis.
Setting the limit to zero allows unlimited access. Enabling a port without
setting a limit will remove any limit that was previously set.
Trapcontrol
Trap Control is setting the IP address for traps. To activate, type:
trapcontrol [on | off] [IPADDR]
The IP address can be changed whenever traps are turned on or off.
Setting the IP address to 0.0.0.0 removes the address.
