Cabletron Systems MMAC-Plus 6, Install Manual

Page: 2 / 2

P/N 9032069 Page 2 of 2
Figure 2 Security Bar Installation
REMOVING SECURITY BARS
The security bars should remain in place while the MMAC-Plus 6 chassis is operating.
Remove the security bars by loosening the two screws which hold each bar in place. Slide the security bars out from
behind the interface module plastic tabs. Be sure to remove both security bars before attempting to remove any
interface modules from the chassis. Set the security bars aside for re-installation.
GETTING HELP
If you need additional support, or if you have any questions, comments, or suggestions concerning this addendum,
contact Cabletron Systems Technical Support:
Phone (603) 332-9400
Monday – Friday; 8
A
.
M
. – 8
P
.
M
. Eastern Time
CompuServe GO CTRON from any ! prompt
Internet mail support@ctron.com
FTP ctron.com (134.141.197.25)
Login anonymous
Password your email address
BBS (603) 335-3358
Modem setting 8N1: 8 data bits, 1 stop bit, No parity
For additional information about Cabletron Systems products, visit our
World Wide Web site: http://www.cabletron.com/
Security Bar
Interface Module
Plastic Tabs
MMAC-Plus 6
Chassis
Tighten with
screwdriver