HSIM-FE6 User’s Guide
2-1
CHAPTER 2
INSTALLATION
To install the HSIM-FE6 the following items are required:
•
Antistatic wrist strap
•
Phillips screwdriver
•
Fast Ethernet (Port) Interface Modules (FEPIMs) in the appropriate
media
2.1
UNPACKING THE HSIM-FE6
Unpack the HSIM-FE6 as follows:
1.
Remove the HSIM-FE6 from the shipping box.
2.
Leave the module in its antistatic bag until you are ready to install it.
3.
Attach the antistatic wrist strap (refer to the instructions on the
antistatic wrist strap package for proper use).
4.
After removing the module from its antistatic bag, visually inspect the
device. If you notice any sign of damage, contact the Cabletron
Systems Global Call Center immediately. Refer to
Section 1.5
for
instructions. Save the antistatic bag in the event the module must be
reshipped.
NOTE
Before attempting to use the HSIM-FE6 you should be familiar
with the
IEEE 802.3, 802.3 10BASE-T,
and
802.3u 100BASE-T
Specifications.
!
CAUTION
The HSIM-FE6 and the host platform are sensitive to static
discharges. Use an antistatic strap and observe all static
precautions during this procedure. Failure to do so could result
in damage to the HSIM-FE6, host module or device.
Summary of Contents for HSIM-FE6
