Installing your USB SuperBooster Dongle
The USB SuperBooster solution has a transmitter unit (sold separately) and a receiver
unit.
Make certain you install the transmitter unit at your computer or
source side. The receiver unit needs to be installed on the device side.
1)
Install the Wall Plate Transmitter in a standard J-box where you want your
source/computer or connect the Dongle Transmitter to your computer
2)
Plug your device into the Dongle Receiver end (USB A side) using a standard
A/B (or A/Mini-B) USB cable
3)
Use a pre-terminated Cat5/Cat5E/Cat6 cable (recommended) or terminate your
own cable using the tool-less RJ45 connectors included to connect the transmitter
and receiver together (see below for instructions on terminating your own cable)
4)
If using a Wall Plate Transmitter, plug your computer into the transmitter end
(USB B side) using a standard A/B USB cable (The green LED will light to
indicate you have a good connection to the wall plate)
5)
Turn your computer/source on and begin using your device
Terminating a Cat5/Cat5E/Cat6 Cable Using the Tool-less IDC
1)
Open the plug by lifting the clear
plastic end
2)
Pin 1 of the connector is on the
left side of the clear plastic shell
while Pin 8 is on the right side of
the connector (with RJ45
connector facing away from you)
3)
Thread the white/orange
conductor on your Cat5/5E/6
cable into Pin 1
4)
Thread the orange conductor on
your Cat5/5E/6 cable into Pin 2
5)
Thread the white/green
conductor on your Cat5/5E/6
cable into Pin 3
6)
Thread the blue conductor on
your Cat5/5E/6 cable into Pin 4
7)
Thread the white/blue conductor
on your Cat5/5E/6 cable into Pin
5
8)
Thread the green conductor on
your Cat5/5E/6 cable into Pin 6
9)
Thread the white/brown
conductor on your Cat5/5E/6
cable into Pin 7
10)
Thread the brown conductor on
your Cat5/5E/6 cable into Pin 8
11)
Repeat steps 1-10 to terminate
the other end of your Cat5/5E/6
cable
Pin 1
Pin 8
3
