www.cabletronix.com
www.nacebrands.com
Note: Extension limit is 180’- Inferior copper clad aluminum (CCA) cable will not work at the
specified distance
Q: What do I do if the
RX “LINK” LED is flashing all the time?
A: 1) Make sure the network cable connection follows the standard of IEEE- 568B.
2) Check whether the TX has a HDMI signal input.
3) Reset the TX&RX
4) Disconnect all cables and reconnect in the following order:
a) Connect HDMI cable to display
b) Connect RJ45 cable to RX
c) Connect RJ45 to TX
d) Connect source HDMI output to TX
e) Connect 5VDC power supplies
f) Push reset on the RX
g) Push reset on the TX
.
Q: The
RX “LINK” led lights are constantly flashing but there is no image output?
A: 1)
Reset the device by pressing the RX “RESET” button.
2) Make sure the HDMI cable is well connected with the monitor.
3) Make sure the network cable is made of fine copper wires
and not copper clad aluminum.
4