Duplex AC Wall Receptacle with Dual USB Charging Ports
Model: 402013
Installation Instructions
Installation Overview
1: Insert a at blade screw driver in one of the
slots at the bottom of the faceplate.
2: Rotate the screw driver to release the
faceplate from the receptacle.
！
CAUTION
Overview
The Cable Matters Duplex AC Wall Receptacle is the ideal solution for creating
a centralized charging station at any wall receptacle in the home or office. It
replaces a single-gang duplex outlet. This convenient wall receptacle provides
multiple options for charging portable devices with dual grounded 15A AC
outlets and dual 2A USB charging ports.
Technical Specifications
：
Electrical Rating: 15A, 125VAC 60Hz
Max Power Rating: 15A/1800 Watts
Operating Temperature: 5° - 104° F
USB Output: DC 5V, 2A
﹒
Installation by a qualified electrician is recommended
﹒
Turn off the power at the electrical service panel before installing
﹒
Use a voltage tester to verify that the power is turned off
﹒
Requires 12-14 AWG copper (not aluminum) wire
﹒
Requires minimum 16-cu" single gang electrical box
﹒
Designed for indoor use only in dry locations
Wiring Instructions
Caution:
Turn off the power at the electrical service panel before and verify with a voltage
meter before installing!
*
Verify that the power has been turned off with a voltage meter.
*
Remove the existing receptacle and disconnect the black, white and green wires.
*
Reserve the screws from the wall box for later.
*
Strip approximately 1/2 inch of insulation from the wire, if necessary.
*
Loosen the screws to the 'L', 'N', and 'G' terminals.
*
Insert the neutral/white wire into the terminal marked 'N' and the live/black wire
into the terminal marked 'L' and tighten the screws.
*
Loop the ground/green wire clockwise about 2/3 of the way around the G
terminal and tighten the screw.
*
Verify that all wires are properly
connected and align the receptacle
before attaching the screws to the
wall box.
*
Remove the protective film cover and
snap on the faceplate. Turn on the
power and test with a voltage meter
before using.
Recommended installation instructions:
Removal instructions:
Note: Remove protective film sheet before using.
1: Feed wires through the
electrical box and wire
the
receptacle according
to the
wiring instructions
above.
2: Install the receptacle using
screws to mount it to the
electrical box.
3: Snap on the faceplate.
Turn the power ON and verify with a volt
meter that the receptacle is working.
Important Note: Consult a qualified electrician for installation in a
split-circuit or middle-of-run electrical receptacle with more than
one set of wires.
