DISTRIBUTION HUB FEATURES
• The CAT5 T6 (C5T6) has one set of RCA inputs and one set of RCA loop-thru
connectors (to go to the next Transmitter or a local monitor) and two RJ-45
jacks CAT5 signal inputs, if both signals are present at same time (RCA and
CAT5), the RCA input signal will be selected automatically.
• If you wish to use the CAT5 input signal, be certain the RCA input cables “are
not connected.”
• The unit allows any Audio/Video source, with Y, Cb, Cr, or Y, Pb, Pr Outputs
(Component), to distribute the Audio and Video to distant locations with
excellent picture quality. The amplifier also supports digital audio (The digital
audio port can be used for composite video if desired.)
• This unit works in conjunction with the CAT5RX (receiver units), which supports
one monitor with component video, right and left audio, and digital audio.
The RX has an adjustable equalizer to compensate for signal loss caused by
long cables.
• An optional external IR system can be used with IR jacks.
• If CAT5 input signal is used, you can loop out that signal via RCA loop out
connectors. Cascade UNITS via RCA loop output or via CAT5.
• Unused RCA connectors do not need to be terminated
SPECIFICATIONS
VIDEO
(All channels including Component and CAT5)
Nominal input level:
1 Volt peak to peak
Gain:
1 Volt into 75 ohms (2 Volts unterminated)
Input impedance:
75 ohms component in
100 ohms twisted pair input
Output impedance:
75 ohms loop out
100 ohms twisted pair output
Isolation port to port:
>45 dB
Isolation out to input:
>65 dB
Return loss:
>20dB
Video Bandwidth:
>75 MHz
Distance:
Maximum distance varies between 400 feet to
500 feet depending upon the type of cable used,
type of receiver, and video resolution.
3 composite video signals may be substituted on the individual component
video inputs (1000 ft. max)
AUDIO
Analog:
Nominal input level:
1 Volt peak to peak
Gain:
Unity (slightly reduced at max. cable length)
Input impedance:
22K ohm Audio IN
100 ohms twisted pair IN
Output impedance:
1K ohm on Loop Out
100 ohms twisted pair OUT
Frequency response:
20 Hz to 100 KHz
Signal to Noise:
80 dB @ 1 Volt Out
Digital:
Supports standard SPDIF digital audio. Unity Gain when terminated into
75 Ohms. (Composite Video is supported on this port.)
POWER
Requirement: External 9 or 10 Volt AC @ 1200 mA with a (2.1mm center)
coaxial barrel connector (Power Supply is included)
Summary of Contents for C5T6
Page 2: ......