M5 Screw
Tighten M5 screw
by S2.5 wrench.
When completed, run water
to check if the installation is
proper. The diagram shows
water flows from the rain
shower.
Water flows from
the rain stream.
Shower Head
M5 Screw
Loosen M5 screw by
S2.5 wrench and carefully
take off the shower head.
Red
Blue
Filters
Blue
Red
Connecting Pipes
Screw off the
connecting pipes
and clean the filters.
Flow water to get rid of
dirt inside the pipes.
V. Maintenance (Diagram 21~24)
If flow rate is lessened after a period of usage, it is possibly because debris
blocks the filters due to poor water quality. Cleaning method should be taken
as followed. First, turn off the main vlave. Take off the filters as shown in the
Diagram 21 and 22. Use brush and vinegar to remove dirt and debris from the
filters, and rinse with clean water. Then use flush water to get rid of dirt and
debris in pipes (Diagram 23), and install the shower head back according to
Diagram 13,17 and 18. Please be noted that the red and blue marks must be
rightly matched.
If water flow from the rain shower becomes lessened or does not spray
evenly, it might be debris blocking the outlet. Gently squeeze those
rubber outlets on the shower head with fingers as shown in Diagram 24. Then
wash debris out with running water.