15
5. Loosen screws (8) of the respective side plates (7a) or (7b) and remove it.
6.
Pull out the guide out of the profile (4a) or (4b) .
7. Check that the other guides are maximum conjoined. In case of not turn it by hand in this position.
8. Pull down the spacer (11) from the removed guide and put it on the new guide.
9.
Put in the new guide into the profile (4a) or (4b) .
10. Attach the gear (1a) or (1b) again.
11. Stretch the belt (3) over all gears.
12. Attach the side plates and make sure that the spindle axle will be in the right bearing.
13. Fix the side plate with the screws (8) again.
6
9
10
maximum away
110 mm
110 mm
Fig.14 Adjusting the guides
14. Turn the knurled knob (6) counter clockwise to get a maximum distance between the guides (9/10) .
15. The distance between the guide blades must be exactly 110 mm. The distance of both guides must be the same.
16. In case of differences between the upper and the lower guides loosen the headless screw (2b) of the upper guide.
17. Adjust the distance via turning the axle by hand.
18. Tighten headless screw (2b) .
19. Mount rear cover.
3.2 on page 7
3
Replacing Assembly Units