10
10
3.1
Contents of Delivery
2
4
3
1
1 Applicator with lift cylinder
2 Screw
(part of the pad)
3 Pad (as ordered)
4 Piercing pin
(at universal tamp pads only)
5 Documentation
Fig. 8
Contents of delivery
i
Notice!
Please keep the original packaging in case the applicator must be returned.
!
Attention!
The device and printing materials will be damaged by moisture and wetness.
Set up label printer with applicator only in dry locations protected from splash water.
3.2
Piercing the Universal Tamp Pad
On the bottom of the pads there are holes for sucking and holding the labels by vacuum. When an universal tamp
pad is delivered these holes are covered by the sliding foil and must be opened according to the label size. For that
purpose a piercing pin is included in the contents of delivery.
!
Attention!
Danger of stab injury in case of inappropriate use.
1
2 3
4
2 mm
Fig. 9
Piercing the universal tamp pad
1. Place a label (1) to be operated on the bottom side of the pad (2). Note the position of the slanted edge (3).
2. Align the label to the side edge in such a way that it reaches over the rear edge of the pad by 2 mm.
3. Open all the holes, which are certainly covered by the label. Open the holes completely by turning the piercing pin
(4) inside the holes
!
Attention!
Do not open holes, which are located less than 1 mm from a label edge.
3
Installation
