13
3.4
Printer Configuration
i
Note!
In that chapter are described the specific applicator parameters of
the menu
Labelling
only.
For more information about the configuration
Configuration
Manual of the printer.
Start menu.
Select
Setup > Labelling.
Parameter
Meaning
Default
Peel-off
position
Shift the position of the dispensed label relative to
the dispensing edge.
The setting can also be adjusted by the software.
The settings of configuration
and software are
added together.
0.0 mm
Teach-in
product
Function to teach the applicator to the tube diameter.
Eject tube
Off
: The tube will be ejected after labelling
On
: The tube will be left in the labelling area after
labelling
Off
Opening width
Setting the distance between the transport rollers
and pressure rollers for tube input
1
Check diam.
Checking the tube diameter before labelling
Off
Teach-in product
Select
Teach-in product
.
The display shows
Step 1/2 Remove tube
.
Remove the tube from the applicator and select
Continue
.
After a short applicator movement the display shows
Step 2/2 Insert tube
.
Insert a tube and select
Continue
.
After a next applicator movement the display shows
Product successfully
taught-in
.
If the result is out of the specification an error message will appear.
Select
Continue
.