14
15
5
Error Messages
5.1
Error Messages of the Printer
For detailed information about printer errors (e.g. 'Paper out', 'Ribbon out', etc.)
Operator's manual of the printer
Error treatment:
Clear the error results.
Press the
feed
key to synchronize the label feed, remove the peeled labels manually.
Press the
pause
key to quit the error state.
After error correction, the printing of the label causing the error will be repeated.
5.2
Error Messages of the Applicator
The following table contains an overview of error messages and their possible causes. It also suggests methods to
resolve the problem:
Error Message
Possible Cause
Vac. plate empty
The Label has been lost on the way or at the waiting position infront of the princh roller
before the START signal was received.
Upper position
The label has not arrived at the sensor area 5 sec. after printing or it wasn't detected.
Air pressure ins.
Applicator is not switched on.
Table 3
Error messages of the applicator
Error treatment:
Clear the error results.
Press the
pause
key to quit the error state.
i
Note!
When receiving errors check the settings and adjustment parameters in the service manual.
After error correction, the printing of the label causing the error cannot be repeated without re-starting the print
job.
Except at the error "
Vac. plate empty"
.
In this case, the last label will be printed again after the error state
has been exited with the
pause
key and by then pressing the Enter button .
In the application mode "Apply/Print" sends the signal "Print first label" and pressing the button
will send the
printed label to the applicator.
