CAB 4114 Series, Service Manual

Page: 6 / 44

6 6 2 Product Description
2.1 Important Features
• The supporting air and the vacuum as well as the speed of the cylinder are adjustable. That way the applicator
can be adapted to different label materials and sizes.
• To avoid contamination within the vacuum channels they are cleaned by air pressure impulse at the end of each
application.
• For operation in a system the I/O interface of the printer can be used.
2.2 Technical Data
Label transfer method Tamp pad Tamp pad
with foam Tamp pad
with label stop
Blow pad
4114/16 L/R 11 F 4114/16 L/R 12 F 4114/16 L/R 61 F 4014 L/R 2100
Label width in mm for 2 4 - 58 10 - 58 10 - 58 10 - 58
for 4 10 - 114 10 - 114 10 - 114 10 - 114
for 6 50 - 174 50 - 174 50 - 174 -
Label height in mm for 2 4 - 80 8 - 80 4 - 80 10 - 80
for 4 8 - 80 8 - 80 8 - 80 10 - 80
for 6 8 - 80 8 - 80 8 - 80 -
Compressed air pressure 0.45 MPa (4.5 bar)
Sound pressure level under 74 dB(A)
Product during
labeling
fixed
¢ ¢ ¢ ¢
in motion - - - -
Labeling onto the
product
from the top
¢ ¢ ¢ ¢
from below
¢ ¢ ¢ ¢
sideways
¢ ¢ ¢ ¢
Product height
fixed
- - -
¢
variable
¢ ¢ ¢
-
Product distance to lower edge
at cylinder stroke
200 mm up to mm 135 135 135 140
300 mm up to mm 235 235 235 240
400 mm up to mm 335 335 335 340
Immersion depth pad F
2)
up to mm
100 100 100 -
Cycle time about frequency/min.
1)
30 30 30 30
Label transfer method Silicon pad
4114/16 L/R 8800 F
Label width in mm for 2 10 - 58
for 4 10 - 114
for 6 50 - 174
Label height in mm 8 - 80
Compressed air pressure 0.45 MPa (4.5 bar)
Sound pressure level under 74 dB(A)
Product during
labeling
fixed
¢
in motion -
Labeling onto the
product
from the top
¢
from below
¢
sideways
¢
Product height variable
¢
Product distance to lower edge
at cylinder stroke
200 mm up to mm 135
300 mm up to mm 235
400 mm up to mm 335
Immersion depth pad F
2)
up to mm
100
Cycle time about frequency/min.
1)
30
Table 1 Technical data
1)
Determined at 100 mm stroke below device/smallest label height/print speed 100 mm/s.
2)
Immersion depth at applicator >25 mm, the cover of the
must be modified.