Instruction manual c-ident handheld terminal HT11
c-trace 05.08.2015, Version 2
page 4 / 11
Important:
During the start-up phase, leave the device switched on for as long as possible (eg in
online mode), so that the battery can be fully charged. To achieve the full battery
performance it is recommended to charge and discharge the device completely in the
first two cycles.
Please do
NOT
use non-rechargeable batteries. The device might accidentally be charged
and damaged (e.g. when connecting to a computer via USB cable).
Please make sure that the handheld does not heat up over +60°C.
Turn on the handheld by pressing any key. Turn it off by pressing F3 for a few seconds.
The office software offers three modes that can be set via function set mode (see
Chapter 2):
Barcode-tag allocation (Marry)
: The chip number and barcode along with a
time stamp and a GPS coordinate, if available, are stored in the internal memory
of the HT11.
Barcode-tag allocation with additional information
: The chip number,
barcode and additional information along with a time stamp and a GPS coordinate,
if available, are stored in the internal memory of the HT11.
The additional information (status) is selected from a stored list by using the
arrow keys on the device. With F1 and F2 you scroll down the list and take over
the selected status with F3.
Emptying
: The chip number or the barcode along with a time stamp and a GPS
coordinate, if available, are stored in the internal memory of the HT11.
Emptying with additional information:
The chip number OR the barcode and
additional information along with a time stamp and a GPS coordinate, if available,
are stored in the internal memory of the HT11.
1.4
Driver Software
Is a prerequisite for effective communication that the USB port is set up correctly. Open
the folder
USB Treiber
on the CD supplied. Click the right mouse button on
USB_Treiber
and select
Run as administrator
. If you do not have permission to install the driver, an
error message appears. In this case, please contact your administrator.
Connect the HT11 to your computer with the supplied USB cable. The device driver
software will be installed.
