C.T.M. HS-559, Service Manual

Page: 9 / 14

Service Manual ‐ CTM HS ‐ 559
9
4 ‐ 3 Front wheel
Tool requirement,
12mm hex ‐ key wrench
13mm socket wrench
12mm offset wrench / 17mm offset wrench / 32mm offset wrench
Instruction for disassembly
A. Please turn off the scooter and remove the key. Make sure the ND lever is in D position before this job.
B. Leak some air from wheel before you disassemble the wheel. (refer to 4 ‐ 4)
C. Use a ratchet and socket to remove the front wheel screw from the center hub of the wheel.
D. Separate the tire from the rim.
E. Replace the parts (inner tube or outer tube) as the demand.
F. Install the front wheel nut into the center hub, tighten it as the torque as the above drawing.
Inspection points
When assembling, please use the torque wrench to make sure the tightening torque as the drawing.
Range of tire pressure is around 35~40 psi.