1. Control box
2. Main stem
3. Hand grip
4. Armrest/detector stand
5. Lower stem
6. Twistlock stem adjuster
7. Search-head
8. Search-head retaining screw, washers, nut
9. Search-head lead
10. Loudspeaker
11. Headphone socket (rear of control box)
12. Battery compartment
13. Battery compartment cover
14. On/off/sensitivity control
15. Retune push-button
16. Inland/beach site selector.
14
15
11
6
2
1
8
7
9
10
3
5
naming of the parts
The CS770XD is a lightweight professional format metal
detector with target identification facility. The smart
operating system recognises metal targets which are
likely to be worthless. The detector is extremely easy to
use but you will be a better treasure hunter if you take the
time to read this manual carefully and understand what the
controls are doing.
CS770XD - Rapid get you going instructions
Assemble
and adjust for length. Twist surplus lead around the stem.
Insert battery so that the terminals line up easily with the contacts in the battery
compartment. (9volt MN1604, PP3 type )
Switch on
at the on/off/sensitivity control
(14)
Simultaneously press the retune button
(15)
and keep it depressed whilst turning the
Sensitivity Control
(14)
to a point where a tone is just about audible or even a little lower
where the tone is just absent. (known as ‘the threshold point). This position should be found
around the start of the green area on the scale. Release the retune button.
Switch the site selector
(16)
to ‘inland’.
Press the Retune button
(15)
once. Reset the sensitivity (if necessary) to the point where a
tone is just about audible.
Start searching
using a relaxed motion swinging the search-head from side to side as close
to the ground as possible.
C.Scope CS770XD Audio Disc Metal Detector
4
12
13
16
