6
9.3 Admin settings
To enter programming mode
* Admin code #
999999
is default admin code
To exit programming mode
*
Must be pressed after completing programming
Note that to undertake the following programming the administrator must be logged in
To change the admin code
0 New code # New code #
The admin code is any 6 digits
To set admin add card
1 10001 # Read card
To set admin delete card
1 10002 # Read card
To delete admin add card
2 10001 #
To delete admin delete card
2 10002 #
To set the working mode
Standalone access control mode (default)
Reader mode
Set Wiegand bits output
3 11 #
When a valid card is read, relay pulses for the time set in section 9.4
3 13 #
If connecting to an access controller
3 (26-58) #
(Default 26 bits)
9.4 Advanced settings
To enter programming mode
* Admin code #
999999
is default master code
To exit programming mode
*
Must be pressed after completing programming
Note that to undertake the following programming the administrator must be logged in
To set multi card access
Entry by single card (default)
Entry by multiple cards
3 0 #
(default)
3 2-10 #
2-10 is the number of cards that must be read one after
another to gain access. Cards must be read within 5 seconds.
To set the relay pulse time
4 0-300 #
0-300 is the time in seconds the relay switches for when a
valid card(s) is read. 0 equals 50mS
To set the relay to latching mode
3 12 #
Read valid card, relay switches. Read valid card again, relay switches back
Device lockout and alarm settings
Normal mode (default)
Alarm mode
Locked out mode
8 0 #
No alarm or lockout (default mode)
8 1 #
The built-in buzzer will alarm if 5 consecutive invalid cards are read
8 2 #
The device will be locked out for 10 minutes if 5 consecutive invalid cards are read
To set alarm time
5 0-99 #
0-99 is the alarm time in minutes (default = 0)
Light indicator setting
Disable red light indicator
Enable red light indicator (default)
8 3 #
Red LED indicator off in standby mode
8 4 #
Red LED indicator on in standby mode (default)
Buzzer setting
Disable buzzer
Enable buzzer (default)
8 5 #
No buzzer when card read
8 6 #
Buzzer sounds when card read (default)
