SAND FILTER INSTRUCTION MANUAL
pag. 2 di 8
www.cpa-piscine.it
Rev.01
–
26/04/21
Warning
Prior to assembling and using this product, carefully read and adhere to all caution and important notices located throughout this
manual. Failure to comply with these instructions may damage the product or cause serious personal injury or death.
Due to the constant technical evolution of this product, we reserve the right to incorporate modifications to the product for its
betterment.
Always read the instructions before using the equipment and before proceeding with installation and assembly and disassembly
operations. Retain the instructions.
This equipment is not intended for use by persons (children under the age of 8 inclusive) with reduced physical, mental and
sensory abilities or lack of adequate experience and knowledge, unless they are supervised and instructed in safe use of the
equipment and whether the associated risks have been understood.
Introduction
You have just bought a technical product whose manipulation is simple without complications if you take the following precautions.
So please read all these instructions carefully.
For the monobloc to function, it needs a skimmer (a device to vacuum the pool water surface). It can be a skimmer built into the
steel wall, or a raised skimmer fixed to the steel wall.
To order replacement parts, please contact your supplier indicating the type and reference number with the purchase date.
Safety details for the electrical installation
1.
The electrical installation must be carried out by an approved electrician. An automatic differential switch (30mA) must
protect the electrical supply.
In addition, the connections must conform to the directive VDE.
1.
No reclamation will be accepted for the consequences resulting from an incorrect installation or start-up, or for non-
compliance with the instructions, the electrical installation is subject to.
2.
The electrical supply cable must not be buried.
3.
Make sure that the electrical supply cable is not damaged (for example by a lawnmower). Every damaged supply cable
must be substituted straight away.
4.
Keep children away from all electrical equipment. Never allow children to operate this equipment. Parents are responsible
for their children.
5.
Do not operate the system while the pool is in use.
Determining the position of the monobloc
Determine the place for the monobloc between the skimmer and the pump inlet with a minimum distance of 3,5 m between the
pool wall and the monobloc. Cut the area of grass (according to the size of the monobloc) and level the area with a spirit level. We
recommend placing the monobloc on concrete slabs or similar. The monobloc must in no way be placed in a low place or directly
on the earth (risk of flooding or overheating or the monobloc motor).
If the pool is buried, totally or partially, the monobloc must be installed in a filtration pit beside the pool.
When the monobloc is installed in a filtration pit, it is necessary to assure there is no danger of flooding.
It is advisable to have a base of small stones in the base of the pit to assure a good filtration of rainwater and the evacuation of
any water in the area. It is also advisable to install a submergible pump with a float switch in case of flooding.
Check that the installation is in no way closed hermetically, this could damage the monobloc pump due to the formation of water
condensation. The size of the pit must be big enough to allow maintenance or repair of the monobloc.
