User’s manual
3
）
Open device
PC hyper terminal will show the prompt requiring username, if it does not
show up please press “Enter” in the keyboard
4
）
Log in device, change IP address
The same operation as Telnet method
Log-in account/password of console port can be checked by command
“ device infor”
9. Installation
9.1 Mechanical Installation and Power Connection
Turn off the key switch on front panel, then insert optical transmitter to the
slot of the rack, after ensuring the correct installation position, use straight
screwdriver to twist mounting screws on the front panel until the optical
transmitter is fixed on the rack.
Turn off power switch, then connect 220V power
9.2 Fiber and RF signal Connection
Fiber Connection
Clean all connecting fiber connectors and flanges. Cleaning steps as below:
①
Take off the dust cover of fiber connector FC/APC, use clean anhydrous
alcohol wipes to clean the end face of FC/APC connector
②
Take off the dust cover of FC/APC connecting flange on device panel
③
Use compressed air to clean FC/APC connector and connecting flange
④
If there is no compressed air to use, dedicated cotton sliver can also be
used to clean SC/APC connecting flange on the machine
Input RF Signal Connection
①
Check whether input RF signal is in the range regulated by this manual
②
Connect suitable RF signal to [RF signal input port]
