C H Byron
34, Sherwood Rd
Aston Fields
Bromsgrove
B60 3DR
Contact Details:
433MHz
R&TTE
APPROVED
CH Byron Electrical United Kingdom. www.chbyron.com
A
B
DK
FIN
F
D
GR
LT
IRL
I
L
NL
P
E
S
UK
BG
CZ
EST
H
IS
LV
M
N
SK
SLO
CH
PL
RO
0560
Tel: 0845 2301231
Fax: 01527 557701
Web: www.chbyron.com
E-mail:
Help: Occasionally interference from adjacent receiver sockets and low voltage
products (Transformers) can affect the operating range.
Always Try to locate addition outdoor sockets a minimum of 30cm apart.
Contact:
Helpline: 0845 2301 231
RF Range:
The radio signals operating distance is reduced when the signal has to
pass through walls. The radio signals achieve a range of 30 metres line of sight; this
can be reduced depending on the type of material and localised interference.
Help Section :
WARNING:
You MUST install an earth cable between the origin of the installation and the earth
terminal of the outdoor socket. This must be insulated inside a sleeve protector within
the conduit.
If using metal conduit, earth continuity must be maintained between conduits.Seal
Conduit and conduit entry with a non setting conduit sealant. Contact your local
electrical retailer.
Product Operation:
Pairing/Deleting with Remote Control:
Up to Six remote control units can be paired with each outdoor socket. To pair the
switch and socket together, press the "Learn" button. The LED will start to flash, now
press the selected "On" button on the remote control, the LED will stop flashing. The
units are now paired together, you can test this by pressing the selected "ON/OFF"
button.
Deleting Remote Control:
To delete a remote control that has been paired with an outdoor receiver socket,
simply press the "Learn" button. The LED will start to blink; press the off button on the
remote control, the LED will blink twice to confirm that the remote control has been
removed from the receiver sockets memory.
Remote Socket reset:
To delete all the remote control units from the memory of the receiver socket, hold
the "Learn" button for more than 6 seconds, the LED will start to blink continuously.
Press the learn button again, the LED will blink twice to confirm the deletion of all
remote controls form the receiver memory.
Product Specification:
Remote Control: HE-410
Input: 230V ~50Hz
Range: 30 Metres (Open Distance)
Frequency: 433.92MHz
Max Load: 3000W (Resistive)
IP56 (Lid Clip closed)
Warning:
Never Exceed the Product Specification
WARNING: attaching the outdoor switch to a metallic surface will reduce the
operating distance.
Remove the switch unit from the protective casing, attach the
casing to the wall using the screws and wall plugs provided.
Reinsert the switch unit into the protective casing making sure
the unit is the correct way up.
Switch Installation:
Remote Control: HE-401/402
Input: CR2032 Battery
Range: 30 Metres (Open Distance)
Frequency: 433.92MHz
Changing Battery:
Remove the switch unit from the protective casing, using a small screwdriver
remove the front cover of the switch unit.
Replace the battery with a new CR2032 battery
(Byron SX100), making sure the polarity is correct.
Replace the front cover and reinsert the switch unit into the protective enclosure.
Always refer to the original instruction when using with additional products.
On
Off
Switch 1 Switch 2
